Ares Chronos FP 110 Instrukcja Obsługi Pobierz pdf (Strona 20)

If the helicopter tends to consistently roll or pitch in a

parcular direcon in 3-axis mode, it may be necessary to

mechanically trim the helicopter to achieve opmal ight.

If the helicopter tends to roll to the right in three-axis

mode, the servo pushrods should be adjusted so that the

swashplate leans further to the le. To do this, the right

pushrod should be lengthened by twisng the plasc piece

counterclockwise a number of turns. Then, the le pushrod

should be shortened by twisng the plasc piece clockwise

the exact same number of turns.

If the helicopter tends to roll to the le, the servo pushrods

should be adjusted so that the swashplate leans further to

the right. To do this, the le pushrod should be lengthened

by twisng the plasc piece counterclockwise a number

of turns. Then, the right pushrod should be shortened by

twisng the plasc piece clockwise the exact same number

of turns.

If the helicopter tends to pitch forward, the servo pushrods

should be adjusted so that the swashplate leans further

backward. To do this, both pushrods should be shortened by

Trimming in 3-Axis

Please note that the helicopter must be in 3-axis mode

for mechanical trim, and this trimming should never

be performed with the helicopter in 6-axis mode. Any

adjustments to 6-axis ight should be achieved by

using the cyclic trim buons on the transmier.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Brak uwag

Ares Chronos FP 110 Instrukcja Obsługi Strona 20